THE
USFA RODEO -Long Hunter's-Engraved
Special Features:
1. Rear sights widened from .108 inch to .140 inch
2. Forcing cone cut to 11 degrees
3. Comes with a crisp, no creep trigger pull
4. Replace factory flat “hand” spring. The frame is drilled and
a Ruger style coil spring is installed for reliability.
5. Factory main spring is replaced with a Lee's Gunslinger flat
spring for a smooth, reliable cocking motion while maintaining a
quick hammer drop
6. Factory flat “trigger/bolt” spring is replaced with a wire
spring for added strength.
7. Hammer is relieved .007 inch on each side through hammer slot to
eliminate drag marks. For that special custom look, the hammer is
then jeweled.
Specifications:
Grips: USFA Hard Rubber
Finish: Cowboy Action Matte Blue™
Frame Style: Cross Pin
Revolvers bare Long Hunters signature consecutive serial Numbering
LH 485 and LH 486, (which is no longer done) and are 4 3/4" .38
Special.
Engraving is done by Aspen Filly, a noted and respected Artist,
Engraver and Reproduction specialist, (Located in Denver, Colorado).
Back of cylinder block on frame sport the pattern copied from Ruger
Centennials revolvers and the remainder of the floral pattern is
exemplary.
These guns were purchased new in 2007, and they were used at Hell on
Wheels 2007 and El Dorado - NEVADA State Championship 2007,
Colorado
State Championship 2007. (Less than 250 rounds a piece). They have
been carefully cleaned and put away in their original boxes and
stored in a safe. They can be yours for $2,400 for the pair, plus
shipping via UPS 2nd Day or Fed Ex. to your FFL, CONUS Only.
Will
take additional pictures for serious buyers.
